How do I disable Internet Explorer Enhanced Security?

Disabling Internet Explorer Enhanced Security Configuration

Windows Server 2003 is shipped with security locked down by default. Part of this locking down is Internet Explorer Enhanced Security which is an extra layer of protection when surfing the internet using Internet Explorer.

You can uninstall the entire Configuration, or just for users, or just for Administrators.

The un-installer is set up like this:

Enhanced Security

->For Administrators

->For Users

If you have non-admin users connecting via Remote Desktop or Terminal Services, you may wish to leave the Users configuration installed. This tutorial will remove it for all users.

Method:

Click Start, then Control Panel, and then select Add/Remove Programs

Click Add/Remove Windows Components

A window will pop-up, click the check mark next to Internet Explorer Enhanced Security Configuration (to uncheck it). If you'd like to only disable it for Administrators or for Users only you can click "Details" and change this setting individually.

Press Next, it will take a couple of seconds to finish, and then it's all done!

For Windows 2008 it is a little different

First, open the Server Manager by going to Start > Server Manager

In the Server Manager browse to the Security Information section in the right hand pane and click 'Configure IE ESC'. IE ESC is located in the very lower right-hand corner of the window.

In the Internet Explorer Enhanced Security Configuration window decide for whom you want IE ESC enabled or disabled and click OK.

It can be enabled/disabled for Administrators only or for all users

 

 

  • 4 Users Found This Useful
Was this answer helpful?

Related Articles

Enabling Audio over RDP on a Windows Server

Please note, it is not necessary to install audio hardware to enable audio for applications...

How do I block a specific IP from my server?

IPSec Filtering First, you will need to open the IPSec snap-in: Start -> Run -> mmc...

How do I change the port that Terminal Services runs on?

1. Select Start, Run and enter 'regedt32'. Locate the following key in the registry:...

How do I configure the Windows Firewall?

Microsoft has developed a great article centered around configuration of the Windows Firewall...

How do I enable ICMP echos in Server 2008

Enable ICMP echos in Server 2008 To enable ICMP replies in Windows Server 2008 you must allow...

Powered by WHMCompleteSolution